LEM Big Bite Meat Grinder 17821 (#32 Head)

The LEM Jerky Slicer/Tenderizer Attachment slices meat up to 1-1/4" thick. Strips of jerky will be 1/4" wide for 14 perfect jerky strips sliced and ready for the oven or dehydrator in seconds. Strips of jerky will be 1/4" wide x 14 strips. Remove the easy off top; replace the slicer shaft with the tenderizer shaft and tenderize even the toughest cuts of meat using the power of your grinder. Easily disassembles for clean up. Body is made of durable powder painted aluminum. No tools or assembly required. Motor not included....

The LEM Juicer/Tomato Strainer attachment for Big Bite meat grinders makes juices, purees, baby food, jams, and jellies. The LEM juicer attachment for the Big Bite grinders features a durable stainless steel head and screen, and its rubber plug and graduated holes maximize juice extraction. Juice extracts into one bowl while the seeds and peels drop into a separate bowl. A pan and stomper are included. Easy to assemble and disassemble for cleaning.

The LEM juicer attachment fits  #5, #8, #12, #22 and #32 Big Bite grinders...

This foot switch can be used to turn your meat grinder (or other machines) on and off, allowing operator free use of hands. Especially useful when stuffing sausage. Ruggedly constructed for long life with full steel housing, nonskid base pad, and textured traction pad. Comes with 8' cord and 3 prong series-plug, prewired. Just plug it in and go (the plug on the end of the foot switch's cord is inserted into 110 volt wall receptacle, then the meat grinder plug is piggybacked into the footswitch plug. So no wiring is...

Three sizes available: 5/8" (15mm), 1" (25mm) and 1-3/8" (35mm) outside diameter. The inside diameter measurements are: 7/16" (11mm), 3/4" (19mm) and 1-1/4" (32mm). Tubes are HD plastic and have very little taper. Use the 1-3/8" tube to fill fibrous casings and old fashioned middles. The 1" tube is great for filling hog casing or 32mm collagen. Use the 5/8" tube for snack sticks and breakfast sausage. 5/8" tube will fit 19mm and 21mm casings.

We also offer a a 2 inch aluminum tube. 

LEM 2" aluminum stuffing tubes fit the LEM Big Bite grinders. Note this is the inside diameter measurement. The outside diameter measures 2-1/4" (57mm).

LEM makes their grinder knives with the highest standards for hardness and quality that are hard to find elsewhere. Made of stainless steel, each knife lasts longer than carbon and is resistant to rust.

Stainless Steel Meat Grinder Plates (reversible).

Note: A knife and plate develop a mated wear pattern as they operate together (same as a piston in an engine cylinder sleeve), so it's important to always keep them together as a set. When you reverse the plate to start using the new side, you should use a new knife. Using an unmatched knife/plate set will cause bad performance, rapid wear and possibly breakage. So you will normally want to have two blades for every plate.