Thunderbird 300E Meat Grinder (#12 head)

Stainless Steel Meat Grinder Plates (reversible) for ThunderBird 300E meat grinders made since 2010. If your ThunderBird 300E model is older than 2010, these plates may not fit.

Note: A knife and plate develop a mated wear pattern as they operate together (same as a piston in an engine cylinder sleeve), so it's important to always keep them together as a set. When you reverse the plate to use the new side, use a new knife. Using an unmatched knife/plate set will cause bad performance, rapid wear and possibly breakage. So...

This stainless steel knife fits the Thunderbird #12 300E meat grinder made since 2010. If your ThunderBird 300E model is older than 2010, this knife may not fit correctly.

Three sizes available: 5/8" (15mm), 1" (25mm) and 1-3/8" (35mm) outside diameter. The inside diameter measurements are: 7/16" (11mm), 3/4" (19mm) and 1-1/4" (32mm). Tubes are HD plastic and have very little taper. Use the 1-3/8" tube to fill fibrous casings and old fashioned middles. The 1" tube is great for filling hog casing or 32mm collagen. Use the 5/8" tube for snack sticks and breakfast sausage. 5/8" tube will fit 19mm and 21mm casings.

We also offer a a 2 inch aluminum tube. 

This foot switch can be used to turn your meat grinder (or other machines) on and off, allowing operator free use of hands. Especially useful when stuffing sausage. Ruggedly constructed for long life with full steel housing, nonskid base pad, and textured traction pad. Comes with 8' cord and 3 prong series-plug, prewired. Just plug it in and go (the plug on the end of the foot switch's cord is inserted into 110 volt wall receptacle, then the meat grinder plug is piggybacked into the footswitch plug. So no wiring is...